Anker SOLIX F3000 + PS400 Bifacial Solar Panel Review (2026): A Spec-Based Look
As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.
This listing pairs the Anker SOLIX F3000, a 3,072Wh LiFePO4 station on wheels, with Anker's PS400 bifacial folding panel. The panel is what sets this kit apart: it weighs 21.9 lb, folds to 22.3 x 38.7 x 3.2 in, is rated IP68, and Anker says the rear face adds up to 10% more output than a one-sided panel. One 400W panel uses only a slice of the F3000's 2,400W solar input, though, so this is a starter kit you will likely add panels to. The listing gives no continuous AC output figure; the 6,000W in the title is the recharge input. We read Anker's listing and did not test the kit.
What stands out
- 3,072Wh LiFePO4, expandable to 24kWh
- 2,400W solar input via 165V or 60V ports
- 3,600W pass-through from a 120V generator
- PS400: 21.9 lb, IP68, bifacial
- 125 h AC idle standby (Anker)
- 190W fridge for 42 h (Anker)
Who it fits
Good fit for
Homeowners and RV owners who want a 3kWh backup station plus one portable panel to start building a solar setup.
Who should skip it
Buyers who need a full solar refill in one day from the box, or a stated continuous AC rating before spending this much.
Verdict: A big home-backup station with one excellent portable panel; plan to add more for real solar charging.
F3000 + PS400 figures in context
3,072Wh LiFePO4
Anker says a 190W fridge runs 42 hours.
2,400W solar input
Six times what one PS400 is rated for.
PS400 400W bifacial
Up to 10% extra from the rear face, per Anker.
3,600W pass-through
Run loads while a 120V generator recharges it.
91.5 lb, 25.6 x 11.8 x 14.8 in
Same as the bare F3000 listing, so the station alone.
Expandable to 24kWh
With Anker F3000 expansion batteries.
Two packages: F3000 and PS400
Package 1 holds the F3000, an AC charging cable, a high-voltage solar charging cable, a manual, a warning notice and a warranty card. Package 2 holds the PS400 panel, two 8.2 ft (2.5 m) solar cables, a 1.6 ft (0.5 m) XT60i solar cable, a quick start guide and a safety card. Anker gives the PS400 a reinforced aluminum frame and an impact-resistant build. The F3000 dimensions and weight match the station-only listing.
Charging the F3000 from one PS400
Unfold the PS400 on reflective ground such as concrete or sand to make the most of its rear face, and plug it into the 60V port. In good sun one 400W panel adds a fraction of the 3,072Wh each day; it can offset a fridge, but refilling the whole battery from solar needs several panels on the 165V port. During outages, a 120V generator can feed up to 3,600W through while the F3000 runs the house loads.
Before buying the F3000 PS400 kit
Think past the first PS400.
Check before you buy
- You can roll a 91.5 lb F3000 to where it will sit
- You plan to add panels beyond the one PS400 over time
- You will ask Anker for the F3000 continuous AC rating
- You have reflective ground for the PS400 rear face
The product at a glance
Anker SOLIX F3000 with 400W Solar Panel
Best for: Home backup with solar
- Capacity
- 3,072Wh
- Battery Chemistry
- LiFePO4
- Solar Panel Wattage
- 400W
- Application
- Home, Outdoor, Emergency, RV
- Panel Type
- Bifacial
- Dimensions
- 25.6 × 11.8 × 14.8 inches
View on Amazon: Anker SOLIX F3000 with 400W Solar Panel Affiliate link
Anker's F3000 (3,072Wh LiFePO4, 2,400W solar input, 3,600W pass-through, expandable to 24kWh) sold with the 21.9 lb IP68 PS400 bifacial panel.
Pros
- PS400 is light and IP68
- Big 2,400W solar input
- 3,600W generator pass-through
- Expands to 24kWh
Cons
- One panel is a slow refill
- No continuous AC figure
- 91.5 lb station
Good fit if
- You want 3kWh of home backup
- You will add panels over time
Skip if
- You want a full solar refill from one PS400
- You need to carry the F3000 by hand
Verdict: A 3kWh backup station with one strong portable panel.
Specifications side by side
| Spec | Anker SOLIX F3000 with 400W Solar Panel |
|---|---|
| Capacity | 3,072Wh |
| Battery Chemistry | LiFePO4 |
| Solar Panel Wattage | 400W |
| Wattage | 400W |
| Application | Home, Outdoor, Emergency, RV |
| Panel Type | Bifacial |
| Dimensions | 25.6 × 11.8 × 14.8 inches |
| Weight | 91.5 pounds |
| Color | Black |
| Model | A1782 |
Frequently asked questions
How much solar can the Anker F3000 take?
Anker lists 2,400W of F3000 solar input, split across a 165V and a 60V port.
How heavy is the PS400 panel in the F3000 kit?
21.9 lb, folded to 22.3 x 38.7 x 3.2 in.
Is the PS400 waterproof?
Anker rates the PS400 IP68.
Do the F3000 and PS400 arrive together?
No, they ship in two packages.
Can the F3000 be charged by a gas generator?
Yes, through a 120V generator with 3,600W pass-through.
Featured in
See also
- generac iq3500 gas inverter generator review
- growatt helios 3600 dual unit double voltage hub review
- oupes mega 1 lite 240w solar panel review
- anker solix c200 DC portable power station review
- anker solix f3000 portable power station review
- Anker SOLIX E10 7.6kW Home Battery Backup Review: Who It Fits and Who Should Skip It
- Anker SOLIX C200 DC 192Wh with 60W Solar Panel Review (2026)
- Anker SOLIX F3000 + BP3000 Expansion Battery Bundle Review (2026)
- anker solix f3000 3072wh 6000w review
- arctwonder solar panel rooftop tent review
