As an Amazon Associate we earn from qualifying purchases. Affiliate disclosure

BLUETTI PV100FX 100W Flexible Solar Panel 2-Pack Review: Who It Fits and Who Should Skip It

Latest update:

As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.

This BLUETTI listing is a pair of PV100FX flexible panels, 2 x 100W, sold mainly for BLUETTI's RVSolar 48V system but described as working with other setups. Each panel uses mono PERC cells rated at 23.4%, bends through 240° to follow a curved RV roof, boat or rooftop tent, and carries an IP67 rating. BLUETTI says they mount with adhesive, hooks or ties, no drilling, and the box holds two panels, two pairs of parallel cables and a manual. What the listing does not give is the electrical side: no Voc, Vmp or current per panel, so wiring for a 48V system has to come from BLUETTI's manual or support. The 9.7 lb weight is most likely the pair. We built this from BLUETTI's listing.

What stands out

  • Two 100W flexible panels in one box
  • 23.4% mono PERC cells
  • Bends to 240°
  • IP67 rated
  • Two pairs of parallel cables included

Who it fits

Good fit for

BLUETTI RVSolar owners and RV or boat owners with curved roofs who want a matched pair of stick-on panels and are happy to wire from BLUETTI's manual.

Who should skip it

Anyone who needs Voc and Vmp up front to size a controller or series string, and buyers who only need 100W.

Verdict: A matched flexible pair for BLUETTI's RV system; ask for the electrical specs before wiring it to anything else.

BLUETTI PV100FX pair, figure by figure

2 x 100W

200W rated in total; flexible panels usually deliver less when bent or hot.

23.4% mono PERC

A standard cell type for flexible panels at this size.

240° bend

Follows roof curves, but avoid tight folds over edges.

IP67

Rated against dust and temporary immersion.

39.4 x 23.2 in, 9.7 lb

Listed size of one panel; 9.7 lb most likely covers both.

No Voc / Vmp listed

Needed to wire a 48V string or pick a controller; ask BLUETTI.

How the PV100FX pair is built

Each PV100FX is a thin laminate of PERC cells that bends up to 240°, with what BLUETTI calls a standard solar connector, so it plugs into BLUETTI stations and other brands that use the same plug. The two pairs of parallel cables let both panels join into one lead. BLUETTI suggests adhesive, hooks or ties for mounting, which suits fiberglass caps and tent roofs where drilling is unwelcome.

The BLUETTI pair on an RV roof

Laid across a curved RV roof, the two panels can feed the RVSolar 48V system or a BLUETTI station through the parallel cables. For a 48V battery, panels are often wired in series to reach the voltage, so check BLUETTI's manual for whether these should run in series or parallel on your system. Leave airflow under flexible panels where possible, because heat cuts output on glued-down installs.

Before buying the BLUETTI PV100FX 2-pack

A few points to settle first.

Check before you buy

  • You have BLUETTI's Voc and Vmp for the PV100FX before wiring
  • Your roof curve stays within the PV100FX 240° bend
  • You want both PV100FX panels, not a single 100W
  • Your controller or station accepts the BLUETTI connector

The product at a glance

BLUETTI 2-Pack 100W Flexible Solar Panels

Best for: BLUETTI RV systems

Rated Power
100W
Conversion Efficiency
23.4%
Panel Type
Flexible
Cell Type
MONO PERC
System Voltage
48V
IP Rating
IP67

View on Amazon: BLUETTI 2-Pack 100W Flexible Solar Panels Affiliate link

Two 100W bendable PERC panels (23.4%, IP67, 240° bend) with parallel cables, made for BLUETTI's RVSolar 48V system. No Voc, Vmp or current listed; 9.7 lb likely for the pair.

Pros

  • Matched pair with parallel cables
  • IP67 and 240° bend
  • Drill-free mounting

Cons

  • No voltage or current specs
  • Weight per panel unclear

Good fit if

  • You run BLUETTI's RVSolar 48V system
  • You want two PV100FX panels for a curved roof

Skip if

  • You need PV100FX Voc and Vmp before buying
  • One 100W panel is enough

Verdict: A tidy flexible pair for BLUETTI RV setups, thin on electrical specs.

Specifications side by side

Spec BLUETTI 2-Pack 100W Flexible Solar Panels
Rated Power 100W
Conversion Efficiency 23.4%
Panel Type Flexible
Cell Type MONO PERC
System Voltage 48V
IP Rating IP67
Weight 9.7 pounds
Wattage 100W
Application Camping, Marine
Features Solar Charging
Dimensions 39.4 × 3.94 × 23.2 inches
Model PV100FX

Frequently asked questions

Does the BLUETTI PV100FX 2-pack work without the RVSolar system?

BLUETTI says it also works with other power setups using a standard solar connector.

What is the Voc of the BLUETTI PV100FX?

The listing does not state it; ask BLUETTI before building a series string.

How far does the BLUETTI PV100FX bend?

Up to 240°, according to BLUETTI.

What comes in the BLUETTI PV100FX box?

Two 100W flexible panels, two pairs of parallel connection cables and a user manual.

Is the BLUETTI PV100FX waterproof?

BLUETTI rates it IP67.

See also