Renogy 250W N-Type Bifacial Solar Panel Review: Who It Fits and Who Should Skip It
As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.
Renogy's 250W bifacial panel is a single rigid module with N-type 16BB cells rated at 25% efficiency and a glass rear face that also collects reflected light. Renogy lists an 80% bifaciality factor, meaning the back can produce up to 80% of what the front would under the same light, and a -0.29%/C temperature coefficient, which helps in hot summers. At 60.9 x 30 in and 27.3 lb it is sized for an RV roof rack, a boat arch or a ground mount. It suits 12V battery systems through a charge controller. This review is based on Renogy's listing and published specs; we have not tested the panel.
What stands out
- N-type 16BB cells, 25% rated efficiency
- 80% bifaciality factor
- -0.29%/C temperature coefficient
- IP68 rating, low-iron tempered glass
- 60.9 x 30 x 1.2 in, 27.3 lb
Who it fits
Good fit for
RV, boat and ground-mount owners who can leave open space or a light surface behind the panel and want more output per square foot than a 200W rigid panel.
Who should skip it
Anyone mounting flat on a dark roof (the rear face then adds little), and buyers who need Voc, Vmp and Isc before sizing a controller: the listing gives none of them.
Verdict: A well-specified 250W bifacial module for raised mounts; ask Renogy for the electrical sheet before buying.
Renogy 250W bifacial figures
250W rated, 25% cells
Front-side rating; Renogy says 20W more than a p-PERC panel of the same design.
80% bifaciality
Renogy estimates about 14% more rear output than a p-PERC panel; real gain depends on what lies under the panel.
-0.29%/C
Loses less power per degree than typical PERC panels when the cells heat up.
IP68
Junction and frame sealing rated for rain and snow exposure.
60.9 x 30 x 1.2 in
A tall, narrow module; measure RV roof rails before ordering.
27.3 lb
Heavier than a 200W rigid panel because of the glass back.
Renogy 250W bifacial build
Both faces are glass: low-iron tempered glass on the front, with a transparent rear so light reflected from the ground or roof reaches the cells. The frame is corrosion-resistant aluminum and the module carries an IP68 rating. Renogy uses 16 busbars per cell to cut resistance and limit hot spots and microcracks. The listing does not name the connector type, cable length or whether mounting hardware is included.
Getting rear-side output from the Renogy 250W
Bifacial gain needs light behind the panel. On a tilt mount over gravel, concrete, sand or snow, or on brackets that hold it several inches above a white RV roof, the rear face has something to collect. Flush on dark shingles it behaves close to a 250W monofacial panel. Pair it with an MPPT controller sized for your battery bank; Renogy describes it as a 12V-system panel but does not list Voc, Vmp or current, so confirm those before choosing a controller or wiring several in series.
Before buying the Renogy 250W bifacial
Check these points against your mount and controller.
Check before you buy
- Renogy 250W rear face will see open sky or a light surface
- Your rails fit a 60.9 x 30 in Renogy module
- You asked for the Renogy 250W Voc and Vmp before series wiring
- Your mount can carry 27.3 lb per Renogy panel
The product at a glance
Renogy 250W N-Type Bifacial Solar Panel
Best for: Raised RV and ground mounts
- Rated Power
- 250W
- Conversion Efficiency
- 25%
- Panel Type
- Bifacial
- Cell Type
- N-Type
- System Voltage
- 12V
- Busbar Count
- 16BB
View on Amazon: Renogy 250W N-Type Bifacial Solar Panel Affiliate link
Renogy's 250W N-type bifacial module: 16BB cells at 25%, 80% bifaciality, -0.29%/C temperature coefficient and IP68, in a 60.9 x 30 in, 27.3 lb frame. Renogy gives no Voc or Vmp for this 250W module.
Pros
- 25% N-type cells
- 80% bifaciality
- Low heat losses
- IP68
Cons
- No Voc/Vmp listed
- 27.3 lb, heavy for one panel
- Rear gain needs a light surface
Good fit if
- You tilt-mount the Renogy 250W over a light surface
- You want more watts per square foot on an RV rack
Skip if
- You flush-mount the Renogy 250W on a dark roof
- You need the electrical sheet before buying
Verdict: A strong single bifacial module for raised mounts.
Specifications side by side
| Spec | Renogy 250W N-Type Bifacial Solar Panel |
|---|---|
| Rated Power | 250W |
| Conversion Efficiency | 25% |
| Panel Type | Bifacial |
| Cell Type | N-Type |
| System Voltage | 12V |
| Busbar Count | 16BB |
| IP Rating | IP68 |
| Weight | 27.3 pounds |
| Application | Home, RV, Off-Grid, Marine |
| Dimensions | 60.9 × 30 × 1.2 inches |
| Size | 250W Single Panel (N-Type Bifacial) |
| Color | Black |
| Model | N-Type 16BB 250W Bifacial Solar Panel |
Frequently asked questions
How much extra power does the Renogy 250W bifacial rear side add?
Renogy rates bifaciality at 80% and estimates about 14% more rear output than a p-PERC panel; the real figure depends on ground reflectance and mounting height.
Is the Renogy 250W bifacial panel good for an RV roof?
It fits if the roof has room for 60.9 x 30 in and you raise it on brackets; flat on the roof the rear face adds little.
What is the Renogy 250W bifacial panel's Voc?
The listing does not give Voc, Vmp or Isc. Ask Renogy before sizing a controller.
How does the Renogy 250W bifacial panel handle heat?
Its -0.29%/C temperature coefficient means smaller losses in hot weather than typical PERC panels.
What weather rating does the Renogy 250W bifacial panel have?
IP68, with low-iron tempered glass and an aluminum frame.
See also
- renogy 100w 12v solar starter kit review
- renogy e flex 120w foldable solar panel review
- renogy 200w 12v RV solar kit review
- renogy solar panels 50 watt review
- renogy shadowflux solar panel 120 review
- Renogy 200W Lightweight Foldable Solar Panel Review: Who It Fits and Who Should Skip It
- Renogy 400W Portable Solar Suitcase Review: Specs, Pros and Cons
- Renogy 100W Portable Foldable Solar Panel Review: Specs, Pros and Cons
- jjn 850w bifacial n type solar review
- tidyard solar shower review
