Anker SOLIX C1000 Gen 2 + Alternator Charger Review (2026): A Spec-Based Look
As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.
This bundle pairs the Anker SOLIX C1000 Gen 2, a 1,024Wh LiFePO4 station with 2,000W of output (3,000W peak) across 10 ports, with Anker's 800W Alternator Charger. The charger is the reason to choose this listing: Anker says it is up to 8x faster than a car auxiliary port and works with 12V or 24V starter batteries, including lead-acid (flooded, GEL, AGM, calcium) and LFP. It is also bi-directional, so the C1000 Gen 2 can top up an RV house battery or the vehicle's starter battery. At home, HyperFlash recharges the station from AC at 1,600W in about 49 minutes once enabled in the Anker app. We relied on Anker's listing and did not install the kit.
What stands out
- 1,024Wh LiFePO4
- 2,000W output, 3,000W peak, 10 ports
- 800W Alternator Charger, up to 8x a car port
- 12V or 24V vehicles, lead-acid or LFP batteries
- Bi-directional: charge RV or starter batteries
- 49 min full AC recharge at 1,600W
Who it fits
Good fit for
Van-lifers, RV owners and overlanders who drive daily and want a 1kWh station refilled from the alternator, with the option to feed the house battery.
Who should skip it
Anyone without a place to wire a 100A-fused charger to the vehicle battery, or who only charges at home and does not need the alternator kit.
Verdict: A fast-refilling 1kWh station plus a serious alternator charger; worth it only if you will install the charger.
C1000 Gen 2 alternator bundle figures
1,024Wh LiFePO4
A 45W 12V fridge runs about 19 hours; laptops for a work day.
2,000W, 3,000W peak
Runs a microwave or induction plate one at a time.
800W Alternator Charger
Refills most of the 1,024Wh in about 1.5 hours of driving, by simple math.
12V/24V, lead-acid and LFP
Anker says it fits 99% of RVs and gas vehicles.
1,600W HyperFlash AC, 49 min
Enable it in the Anker app for the full-speed charge.
24.9 lb, 15.1 x 8.19 x 9.61 in
Anker says 14% smaller and 11% lighter than similar models.
What ships in the C1000 Gen 2 bundle
The bundle arrives in two packages. Package 1 holds the C1000 Gen 2, an AC charging cable, a quick start guide and a warranty card. Package 2 holds the Alternator Charger, a 1 m PPS XT-60i cable, a 7 m battery cable, a 100A fuse wire, an installation board, screws and a guide. The listing does not break down the 10 ports by type or give the solar input limit.
Driving with the C1000 Gen 2 and charger
Mount the Alternator Charger on its board near the starter or house battery, run the 7 m cable with the 100A fuse, and connect the C1000 Gen 2 through the XT-60i cable. While driving it charges at up to 800W; parked, the same link can send power back to the house battery. At home, plug into the wall with HyperFlash on.
Before buying the C1000 Gen 2 alternator bundle
Plan the vehicle install.
Check before you buy
- Your vehicle runs a 12V or 24V system for the Anker Alternator Charger
- You can route a 7 m cable and 100A fuse to the C1000 Gen 2
- Your battery type is lead-acid or LFP
- You will check the C1000 Gen 2 port types on Anker's page
The product at a glance
Anker SOLIX C1000 Gen 2 with Alternator Charger
Best for: Van and RV charging on the road
- Running Wattage
- 2,000W
- Surge Wattage
- 3,000W
- Capacity
- 1,024Wh
- Battery Chemistry
- LiFePO4
- Output Ports
- 10 ports
- Application
- Home, Outdoor, Emergency
View on Amazon: Anker SOLIX C1000 Gen 2 with Alternator Charger Affiliate link
This bundle pairs Anker's 1,024Wh LiFePO4 SOLIX C1000 Gen 2 (2,000W, 3,000W peak, 10 ports, 49-min AC recharge) with an 800W bi-directional Alternator Charger for 12V or 24V vehicles.
Pros
- 800W alternator charging
- Bi-directional to house battery
- 49 min AC recharge
- Full install kit included
Cons
- Install work needed
- Ships in two packages
- Port types not listed
Good fit if
- You drive daily and want the C1000 Gen 2 filled on the road
- You want to top up an RV house battery
Skip if
- You will not install a vehicle charger
- You only charge at home
Verdict: A 1kWh station with a fast, two-way alternator charger.
Specifications side by side
| Spec | Anker SOLIX C1000 Gen 2 with Alternator Charger |
|---|---|
| Running Wattage | 2,000W |
| Surge Wattage | 3,000W |
| Capacity | 1,024Wh |
| Battery Chemistry | LiFePO4 |
| Output Ports | 10 ports |
| Application | Home, Outdoor, Emergency |
| Dimensions | 15.1 × 8.19 × 9.61 inches |
| Weight | 24.9 pounds |
| Color | Gray |
| Model | A1763 |
Frequently asked questions
How fast does the Alternator Charger fill the C1000 Gen 2?
At up to 800W, which Anker says is up to 8x faster than a car auxiliary port.
Does the Anker Alternator Charger work with 24V vehicles?
Yes, 12V or 24V RV and fuel vehicle starter batteries.
Can the C1000 Gen 2 charge an RV house battery?
Yes, Anker lists bi-directional charging for RV expansion and vehicle battery recharge.
How long does the C1000 Gen 2 take to charge from AC?
About 49 minutes at 1,600W with HyperFlash enabled in the app.
Do the C1000 Gen 2 and Alternator Charger arrive together?
They ship separately in two packages.
Featured in
- Best Generators with LiFePO4: 10 Spec-Based Picks
- Anker Generators: 9 Picks Ranked by Specs
- 7 Best 2000W Generators, Compared
- How to Choose Portable Power Stations: A Complete Buying Guide for 2026
- 10 Best Generators with 1024Wh, Compared
- Best Generators for Outdoor in 2026: 10 Picks Ranked by Specs
See also
- anker solix c2000 gen 2 bp2000 bundle review
- daranener youyo r100 89 6wh power station review
- aferiy p310 3840wh portable power station review
- anker solix c300 DC power review
- anker solix s2000 portable power station review
- Anker SOLIX C1000 1,056Wh Power Station Review (2026): A Spec-Based Look
- Anker SOLIX C2000 Gen 2 Review (2026): 2,048Wh, 2,400W, TT-30 RV Port
- Anker SOLIX F3800 Renewed Review (2026): 3,840Wh, 6,000W, 120V/240V
- anker solix c1000 gen 2 review
- asustor drivestor 2 gen 2 review
