As an Amazon Associate we earn from qualifying purchases. Affiliate disclosure

Callsun CN215W 430W Bifacial Solar Panel 2-Pack Review: Specs, Pros and Cons

Latest update:

As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.

The Callsun CN215W 430W set is two 215W bifacial framed panels, each split into four independent power zones so that shade on one zone does not pull the whole panel down. Wired in series the pair gives 34.74V Vmp, 40.82V Voc and 12.38A Imp, which suits 24V batteries and stations with a 60V solar input; Callsun names the BLUETTI Elite 100 V2 and AC200L and the EcoFlow DELTA line. Each panel measures 56 x 30.2 x 1.38 in. The listing gives 25.4 lb, the same figure as Callsun's single CN215W listing, so read it as the weight of one panel and plan for roughly twice that for the pair. Callsun backs each panel with a 12-year product warranty and a 25-year output guarantee of 84.5%. We went through Callsun's listing and spec sheet; nothing here comes from hands-on use.

What stands out

  • Two 215W bifacial panels, four shade zones each
  • Series pair: 34.74V Vmp, 40.82V Voc, 12.38A
  • N-type 16BB cells, over 25% efficiency claimed
  • 12-year product, 25-year 84.5% output warranty

Who it fits

Good fit for

RV, boat and roof owners whose mounting spot gets passing shade from trees, a mast or a roof rack, and who run a 24V bank or a station that takes about 41V of open-circuit input.

Who should skip it

Owners of stations with a 12-30V solar input who would have to wire the pair in parallel, and anyone who wants a light panel to carry: these are framed glass modules.

Verdict: A sensible shade-tolerant 430W pair for fixed mounts; check the 40.82V series Voc against your station before ordering.

CN215W pair figures in plain terms

430W as 2 x 215W

Two separate framed modules; you can wire them in series or in parallel.

Four power zones per panel

Shade on one zone leaves the other three producing, by Callsun's account.

Series: 34.74V Vmp / 40.82V Voc / 12.38A

Needs a solar input rated above 41V; many 12V-only charge controllers cannot take it.

Bifacial, 7-30% extra claimed

The rear gain depends on what is under the panel: snow, sand or a white roof help, dark shingles do not.

56 x 30.2 x 1.38 in each

A full-size rigid module; measure the roof space for two side by side.

25.4 lb listed

Matches the single-panel listing, so it is per panel, not for the set.

Two framed bifacial modules with split cell zones

Each CN215W is a glass-front module in an aluminum frame with a transparent rear, so light reflected from the ground can reach the back of the cells. The cell area is divided into four zones, each behind its own bypass diode, which is how Callsun claims Vmp stays steady when one zone is covered. The listing does not name the connector type, the cable length or whether mounting hardware ships in the box, so budget for MC4 extension leads and brackets.

Wiring the 430W Callsun set to a station or battery

In series the two panels reach 40.82V open-circuit, which suits a 24V MPPT controller or a station whose solar port takes 60V. On a 12V MPPT controller, wire them in parallel instead: about 17.4V Vmp per panel and roughly twice the current, so check the controller's amp rating. For bifacial gain, mount them tilted and a few inches above a light surface; a flat mount tight against a dark roof gets little from the rear side.

Before ordering the Callsun CN215W 2-pack

Run through these checks.

Check before you buy

  • Your station's solar input accepts the CN215W pair's 40.82V series Voc
  • You have space for two 56 x 30.2 in Callsun modules
  • You will buy MC4 leads and brackets for the CN215W set
  • Your mount can lift the Callsun panels off the surface for rear-side light

The product at a glance

Callsun 430W Bifacial Solar Panels

Best for: Partly shaded fixed mounts

Rated Power
430W (2x215W)
Conversion Efficiency
Over 25%
Panel Type
Bifacial
Cell Type
N-Type
System Voltage
12V/24V, Voc 40.82V
Busbar Count
16BB

View on Amazon: Callsun 430W Bifacial Solar Panels Affiliate link

Two 215W bifacial panels with four shade zones each; 34.74V Vmp / 40.82V Voc in series; 12-year product warranty. Weight is listed per panel.

Pros

  • Four shade zones per panel
  • Bifacial rear side
  • Series voltage and current listed

Cons

  • Connector and cable not named
  • Heavy framed modules

Good fit if

  • Your CN215W mount sees partial shade
  • You run a 24V bank or 60V station input

Skip if

  • Your station takes under 41V of solar input
  • You want a Callsun panel you can carry

Verdict: A shade-tolerant bifacial pair with clear electrical figures.

Specifications side by side

Spec Callsun 430W Bifacial Solar Panels
Rated Power 430W (2x215W)
Conversion Efficiency Over 25%
Panel Type Bifacial
Cell Type N-Type
System Voltage 12V/24V, Voc 40.82V
Busbar Count 16BB
Weight 25.4 pounds
Application RV, Off-Grid, Marine
Features Solar Charging
Voltage 12V, 24V
Dimensions 56 × 30.2 × 1.38 inches
Size 2PCS 215W
Color Black
Model CN215W

Frequently asked questions

What voltage does the Callsun CN215W pair give in series?

Callsun lists 34.74V Vmp, 40.82V Voc and 12.38A Imp for two CN215W panels in series.

Is the 25.4 lb Callsun CN215W weight for both panels?

It matches Callsun's single-panel listing, so it reads as the weight of one CN215W; the pair is roughly twice that.

How does the CN215W handle shade?

Each Callsun CN215W panel has four independent zones, so shade on one zone leaves the rest producing.

What warranty comes with the Callsun 430W set?

Callsun gives each CN215W panel a 12-year product warranty and a 25-year guarantee of at least 84.5% output.

Can the Callsun CN215W pair charge a 12V battery?

Yes in parallel through a 12V MPPT controller; in series the 40.82V Voc is meant for 24V systems or 60V station inputs.

See also