As an Amazon Associate we earn from qualifying purchases. Affiliate disclosure

SOLPERK 20W 12V Solar Maintainer Kit 2-Pack Review

Latest update:

As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.

This SOLPERK listing is a pack of two 20W maintainer kits, each with a small glass panel, an 8A three-stage charge controller and a bracket that turns 360 degrees. The job is narrow: keep 12V batteries from going flat while a boat, tractor, RV, mower or gate opener sits unused. With two kits you can cover two vehicles, or one battery plus a gate or fence charger. SOLPERK names LiFePO4, lithium-ion, AGM, SLA, GEL, EFB and MF batteries as supported. Each panel is about 15 x 13.2 inches; the 6 lb weight is not split per kit. All of this comes from SOLPERK's listing; we have not mounted the kits.

What stands out

  • Two complete 20W kits in one pack
  • 8A three-stage controller with two status lights
  • Covers LiFePO4, lithium, AGM, SLA, GEL, EFB and MF
  • Low-iron tempered glass and aluminum frame
  • 360-degree bracket with pre-drilled holes

Who it fits

Good fit for

Owners of two seasonal 12V machines, such as a boat and a camper, or a farm with a gate opener and an electric fence, who want a set-and-forget trickle charger on each.

Who should skip it

Anyone trying to charge a portable power station or run devices (20W is a maintainer, not a charger for big loads), and anyone needing only one kit, since SOLPERK also sells the 20W kit singly.

Verdict: A tidy way to keep two 12V batteries topped up; it will not recover a deeply drained battery quickly.

SOLPERK 20W kit figures in plain terms

2 x 20W panels

Each kit replaces what a parked battery loses to standby drain; not enough to run loads.

8A controller, three-stage

Stops overcharge, over-voltage and short circuits and shows status on two lights.

12V batteries only

Lead-acid types and lithium/LiFePO4 are named; 24V banks are not.

About 15 x 13.2 x 0.7 in

Small enough for a boat rail, trailer tongue or shed wall.

6 lb listed

Not stated whether that is one kit or the pack of two.

Glass rated for heavy wind and snow loads

SOLPERK lists 2400Pa for wind and 5400Pa for snow, with a frame it calls rustproof.

Inside each SOLPERK 20W kit

Each panel uses monocrystalline cells under low-iron tempered glass in a corrosion-resistant aluminum frame, and SOLPERK claims a lifespan of up to 25 years. The 8A controller sits between panel and battery, draws no power from the battery at night and shows charge state on two indicator lights. The title calls it MPPT, but the bullets only describe it as a three-stage smart controller. The bracket bolts to pre-drilled holes and swivels 360 degrees, and the cables are plug-and-play. SOLPERK's 21%-30% cell efficiency claim is a wide range, so treat it loosely; no Voc or current figures are given.

Using two maintainer kits

Mount one panel where it gets midday sun near each battery, wire the controller to the battery terminals and the panel to the controller, and leave it. Through the off-season the kit offsets the slow drain from clocks, alarms and bilge sensors. For a gate opener or electric fence that runs every day, 20W may only keep pace in sunny months; size up if the battery still drops. Check the two lights now and then to confirm the battery reaches full.

SOLPERK 20W 2-pack fit check

A small kit, but a few points still matter.

Check before you buy

  • Both batteries you want to cover with the SOLPERK kits are 12V
  • You actually need two SOLPERK 20W kits, not one
  • Each SOLPERK panel can face the midday sun where it mounts
  • Your daily load on each battery is small, not a fence running all winter
  • You are fine without Voc and current figures for the SOLPERK 20W panels

The product at a glance

SOLPERK 20W 12V Solar Trickle Charger Kit

Best for: Maintaining two 12V batteries

Rated Power
20W
Conversion Efficiency
21%-30%
Cell Type
Monocrystalline
System Voltage
12V
Weight
6 pounds
Application
RV, Car, Marine

View on Amazon: SOLPERK 20W 12V Solar Trickle Charger Kit Affiliate link

Two 20W 12V maintainer kits, each with a glass-and-aluminum panel (about 15 x 13.2 in), an 8A three-stage controller with two status lights and a 360-degree bracket. For LiFePO4, lithium, AGM, SLA, GEL, EFB and MF batteries on boats, RVs, tractors and gates. 6 lb listed without saying per kit or per pack.

Pros

  • Two kits for two batteries
  • Supports lead-acid and lithium 12V
  • Glass panel, aluminum frame
  • Swivel bracket included

Cons

  • Maintainer only, 20W each
  • MPPT claim only in the title
  • No Voc or current listed

Good fit if

  • You store two 12V vehicles or machines
  • You want a SOLPERK kit on each battery at once

Skip if

  • You need a single SOLPERK 20W kit only
  • You want to recharge a drained battery fast

Verdict: Two neat trickle kits for parked 12V batteries.

Specifications side by side

Spec SOLPERK 20W 12V Solar Trickle Charger Kit
Rated Power 20W
Conversion Efficiency 21%-30%
Cell Type Monocrystalline
System Voltage 12V
Weight 6 pounds
Wattage 20W
Application RV, Car, Marine
Features Solar Charging
Voltage 12V
Water Resistance Waterproof
Dimensions 15 × 13.2 × 0.7 inches
Size 20W MPPT Kit (Pack of 2)
Model FD-EP-230201-1688

Frequently asked questions

How many SOLPERK 20W kits come in this listing?

Two, each with a panel, an 8A controller and a mounting bracket.

Can the SOLPERK 20W kit charge a lithium battery?

SOLPERK lists LiFePO4 and lithium-ion among the supported 12V types, along with AGM, SLA, GEL, EFB and MF.

Is the SOLPERK 20W controller MPPT?

The title says MPPT; the feature bullets describe an 8A three-stage controller without repeating that, so confirm with SOLPERK if it matters.

Can a SOLPERK 20W panel charge a power station?

It is built as a 12V battery maintainer with its own controller; it is far too small to be a useful power station charger.

How big is each SOLPERK 20W panel?

About 15 x 13.2 x 0.7 inches; the listed 6 lb is not split per kit.

See also