As an Amazon Associate we earn from qualifying purchases. Affiliate disclosure

BougeRV Arch 2.0 100W N-Type Flexible Solar Panel (ISE214NN) Review (2026): A Spec-Based Look

Latest update:

As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.

The BougeRV Arch 2.0 100W (model ISE214NN) is a flexible panel for curved roofs on vans, RVs and boats, and it bends further than most: BougeRV rates it to 270 degrees. The cells are N-type with 16 busbars at up to 25%, protected by ETFE rather than PET on top and two fiberglass layers underneath to reduce cracking. It is 38.4 x 24.1 in, 2.5 mm thin and 5.14 lb (plus or minus 0.51 lb), with 2.95 ft leads already attached and hanging holes for straps; adhesive or glass glue also work. The detail to check is voltage: BougeRV lists a 29.4V Voc (plus or minus 5%) and calls it a 24V panel, so it needs an MPPT controller on a 12V battery, and BougeRV warns that some power stations will not accept it. Support is five years of tech help rather than a stated warranty. This review is based on BougeRV's listing and published specs, not on an install.

What stands out

  • Bends up to 270 degrees for curved roofs
  • ISE214NN N-type 16BB cells rated to 25%
  • ETFE top, double fiberglass base
  • 5.14 lb, 2.5 mm thin, 38.4 x 24.1 in

Who it fits

Good fit for

Van, RV and boat owners with a curved or weight-limited roof who run an MPPT controller or a station that accepts a 29V-class panel.

Who should skip it

Owners of a PWM controller on a 12V battery, small stations with a low solar input voltage, and anyone who wants a written product warranty term.

Verdict: A light, very bendy 100W panel; confirm your controller or station handles its 29.4V Voc.

BougeRV ISE214NN figures explained

100W, N-type 16BB, up to 25%

A compact 100W footprint for its output.

Voc 29.4V plus or minus 5%

A 24V-class panel; use MPPT for 12V batteries.

270-degree flex

Follows curved roof lines and boat hardtops.

5.14 lb, 2.5 mm

Adds little roof weight; can be glued down.

2.95 ft leads

Short; plan an extension cable to the controller.

5-year tech support

Support from BougeRV, not a stated warranty.

Build of the BougeRV Arch 2.0 100W

BougeRV pairs an ETFE surface, which it describes as anti-scratch, self-cleaning and sand-proof, with a double fiberglass backing that stiffens the cells against impact. Hanging holes sit along the edge; tape for adhesive mounting is sold separately. The leads are pre-attached at 2.95 ft. The listing does not give Vmp, current or the connector type.

Mounting and wiring the ISE214NN

Glue or tape it to a clean curved roof, or strap it through the holes for a temporary setup. On a 12V battery, run it through an MPPT controller rated for at least 30V input; a PWM controller would waste the extra voltage. For a portable station, check the solar input range first, as BougeRV itself advises. BougeRV says series wiring suits 24V and 48V banks. Choose this over the BougeRV Arch 2.0 200W if your roof space is tight or curved at the front; choose the 200W for more output per lead run.

Before ordering the BougeRV ISE214NN

Check these against your setup.

Check before you buy

  • Your controller or station accepts the ISE214NN's 29.4V Voc
  • You use an MPPT controller with a 12V battery
  • You have 38.4 x 24.1 in of roof for the BougeRV Arch 2.0
  • You will add an extension to the 2.95 ft BougeRV leads

The product at a glance

BougeRV Arch 100W Flexible N-Type Panel

Best for: Curved roofs

Rated Power
100W
Conversion Efficiency
Up to 25%
Panel Type
Flexible
Cell Type
N-Type monocrystalline
System Voltage
24V (29.4V Voc)
Busbar Count
16BB

View on Amazon: BougeRV Arch 100W Flexible N-Type Panel Affiliate link

100W N-type 16BB flexible panel (ISE214NN), 270-degree bend, ETFE over double fiberglass, 5.14 lb, 2.5 mm, 38.4 x 24.1 in; Voc 29.4V, 2.95 ft leads.

Pros

  • Bends to 270 degrees
  • ETFE top and double fiberglass
  • Light at 5.14 lb

Cons

  • 29.4V Voc limits PWM and some stations
  • Short 2.95 ft leads, no warranty term

Good fit if

  • You have a curved van or boat roof
  • You run MPPT with the BougeRV panel

Skip if

  • Your controller is PWM on 12V
  • Your station's solar input tops out below 30V

Verdict: A light, flexible 100W for curved roofs and MPPT systems.

Specifications side by side

Spec BougeRV Arch 100W Flexible N-Type Panel
Rated Power 100W
Conversion Efficiency Up to 25%
Panel Type Flexible
Cell Type N-Type monocrystalline
System Voltage 24V (29.4V Voc)
Busbar Count 16BB
Weight 5.14 lbs
Wattage 100W
Application Camping, Home, RV, Marine
Voltage 24V
Dimensions 38.4 × 24.1 × 0.1 inches
Size 100W/38.35''*24.09''
Color Black
Model ISE214NN

Frequently asked questions

What is the Voc of the BougeRV ISE214NN?

29.4V plus or minus 5%, per BougeRV.

Can the BougeRV Arch 2.0 100W charge a 12V battery?

Yes, through an MPPT controller; its voltage is 24V-class.

How far does the BougeRV ISE214NN bend?

BougeRV rates it to 270 degrees.

How heavy is the BougeRV Arch 2.0 100W?

5.14 lb, plus or minus 0.51 lb, at 2.5 mm thick.

What support comes with the BougeRV ISE214NN?

Five years of tech support and a one-on-one solar plan; no warranty term is stated.

See also