BougeRV Arch Pro 100W Flexible Solar Panel (SP003) Review: Specs, Pros and Cons
As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.
The BougeRV Arch Pro 100W (SP003) is a fiberglass flexible panel for curved van, RV and car surfaces, and it is one of the bendiest on the market: BougeRV gives up to 270 degrees. It is about 2.5mm thick and weighs 4.63 lb, with N-type 16BB cells rated at 25% under ETFE rather than PET, which BougeRV says will not delaminate. Upgraded bypass diodes are meant to hold output under partial shade and limit hot spots. Installation options include hanging holes, adhesive backing or glass glue, and the panel ships with 2.95 ft pre-attached leads. The listing title says 24 Volts, while a bullet says one panel charges 12V and several in series reach 24V or 48V, so ask BougeRV for Voc and Vmp before choosing a controller. The size field gives 38.35 x 24.09 inches. Support is 5 years of tech help. We read BougeRV's listing; we have not mounted the panel.
What stands out
- Bends up to 270 degrees
- 2.5mm thin, 4.63 lb
- N-type 16BB cells at 25%, ETFE
- Bypass diodes for partial shade
Who it fits
Good fit for
Van, car-roof and RV owners with tight curves or a shaded roof who want a light 100W flexible panel with a durable ETFE top.
Who should skip it
Buyers who need a clear voltage figure before wiring, and anyone wanting a longer warranty than 5 years of tech support.
Verdict: A very bendable, shade-aware 100W flexible; clarify the voltage.
BougeRV Arch Pro SP003 figures explained
100W, N-type 16BB, 25%
BougeRV's rating for the cells; real output depends on heat and angle.
270-degree bend
Fits the curve at the front of a van or car roof.
2.5mm, 4.63 lb
Thin and light enough for weight-limited roofs.
Bypass diodes
Cut the loss when part of the panel is shaded.
24V title vs 12V bullet
Ask BougeRV for Voc and Vmp before buying a controller.
2.95 ft leads
Under a yard of lead on the Arch Pro, so budget for an extension run.
How the Arch Pro is built
BougeRV laminates the cells in fiberglass under ETFE, which resists scratches, sand and abrasion better than PET. The panel can hang from its holes, stick down with adhesive backing, or bond with glass glue; BougeRV sells separate tape for a quicker install. The connector type on the leads is not named.
Mounting the Arch Pro on a vehicle
Clean the roof, follow the curve, and fix it with adhesive or through the holes, then run an extension to the controller. Choose the Arch Pro SP003 over BougeRV's Arch 2.0 100W (ISE214NN) if you need the tighter 270-degree curve and shade handling; choose the Arch 2.0 if you want a listing that states Voc.
Before buying the BougeRV Arch Pro 100W
Check these points.
Check before you buy
- You have the Arch Pro SP003 Voc and Vmp from BougeRV
- Your roof fits 38.35 x 24.09 in of Arch Pro panel
- You have an extension for the Arch Pro's 2.95 ft leads
- Your curve stays inside the Arch Pro's 270 degrees
The product at a glance
BougeRV Arch Pro 100W Flexible Solar Panel
Best for: Curved van and car roofs
- Rated Power
- 100W
- Conversion Efficiency
- 25%
- Panel Type
- Flexible
- Cell Type
- N-Type
- System Voltage
- 24V
- Busbar Count
- 16BB
View on Amazon: BougeRV Arch Pro 100W Flexible Solar Panel Affiliate link
BougeRV Arch Pro SP003: 100W N-type 16BB fiberglass flexible at 25%, ETFE, up to 270-degree bend, 2.5mm, 4.63 lb, bypass diodes, 2.95 ft leads, 38.35 x 24.09 in; 24V title vs 12V bullet, no Voc listed.
Pros
- Tightest bend in its class
- Light at 4.63 lb
- Shade-aware diodes
Cons
- Voltage wording unclear
- Short 2.95 ft leads
Good fit if
- Your van's curved roof front needs the BougeRV Arch Pro
Skip if
- You want the Arch Pro's voltage printed before ordering
Verdict: A light, very flexible 100W for curved vehicle roofs.
Specifications side by side
| Spec | BougeRV Arch Pro 100W Flexible Solar Panel |
|---|---|
| Rated Power | 100W |
| Conversion Efficiency | 25% |
| Panel Type | Flexible |
| Cell Type | N-Type |
| System Voltage | 24V |
| Busbar Count | 16BB |
| Weight | 4.63 lbs |
| Wattage | 100W |
| Application | Camping, Home, RV, Marine |
| Voltage | 24V |
| Dimensions | 40.6 × 1.77 × 26.3 inches |
| Size | 100W/38.35*24.09IN |
| Model | SP003-BKUSEA |
Frequently asked questions
How far does the BougeRV Arch Pro 100W bend?
Up to 270 degrees, per BougeRV.
Is the BougeRV Arch Pro SP003 12V or 24V?
The title says 24V; a bullet says one panel charges 12V and series strings reach 24V or 48V, so confirm with BougeRV.
How heavy is the BougeRV Arch Pro 100W?
4.63 lb, about 2.5mm thick.
How do you mount the BougeRV Arch Pro SP003?
By its hanging holes, adhesive backing or glass glue; tape is sold separately.
Does the BougeRV Arch Pro handle shade?
BougeRV fits upgraded bypass diodes to keep output steadier under partial shade.
See also
- ecoboss 400w tuv n type solar panel 2 pack review
- ugreen nexode 25188 100w 20000mah power bank 2 pack review
- anker prime a1903 220w power bank charging base review
- bougerv arch pro 200w anti shading review
- bougerv 100w portable solar panel review
- BougeRV ISE239N 300W Bifacial N-Type Solar Panel Review
- BougeRV Arch 2.0 200W N-Type Flexible Solar Panel Review (2026): A Spec-Based Look
- BougeRV Arch 2.0 100W N-Type Flexible Solar Panel (ISE214NN) Review (2026): A Spec-Based Look
- omtech pro 100w co2 laser review
- omtech pro 100w co2 laser engraver review
