EtnalSolar 400W N-Type Solar Panel 2-Pack (2x200W) Review
As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.
This EtnalSolar set is two GB200W-B02 rigid panels, 200W each, for 400W in total. The cells are 18-busbar N-type rated up to 25.6%, set behind 3.2mm low-iron tempered glass in an anodized frame with corner guards and an IP68 rating. Each panel is listed at 52.8 x 26.4 x 1.18 inches and 19.6 lb (the figure matches EtnalSolar's single-panel listing, so it reads as per panel). The paperwork is strong for the price: a 10-year material and workmanship warranty and a 30-year output guarantee of 87.4%. Voc, Vmp and current are not given. This review reflects EtnalSolar's listing; we have not mounted the pair.
What stands out
- Two 200W 18BB N-type panels, up to 25.6%
- Bypass diodes for partial shade
- EtnalSolar frame: 3.2mm glass, IP68, guarded corners
- Rated -45°C to 85°C
- 10-year warranty, 87.4% output at 30 years
Who it fits
Good fit for
RV, cabin, farm and trailer owners building a fixed 400W array on a 12V bank, or two panels in series for 24V, who value a long written warranty.
Who should skip it
Anyone who wants a portable folding panel for a power station, roofs too short for a 52.8-inch panel, and buyers who need electrical specs on the listing to size a controller.
Verdict: A well-guaranteed 400W rigid pair for fixed installs; ask for the electrical sheet before choosing a controller.
EtnalSolar 2x200W figures explained
2 x 200W, 18BB N-type
More busbars and N-type silicon for better low-light and hot-weather output, per EtnalSolar.
52.8 x 26.4 x 1.18 in each
Two panels side by side need about 53 x 53 inches of roof.
19.6 lb each
Matches the single-panel listing; about 39 lb for the pair.
≤1.0% first year, 0.4%/yr after
Adds up to the 87.4% output promised at 30 years.
Bypass diodes
Limit the loss when a tree or vent shades part of a panel.
IP68, 2400Pa / 5400Pa
Sealed and rated for wind and snow loads; MC4 leads and pre-drilled holes.
Build of the GB200W-B02
These are conventional framed glass modules: 3.2mm tempered glass, anodized aluminum frame, reinforced corners and pre-drilled holes for Z-brackets or rails. EtnalSolar rates them to work from -45°C to 85°C and says they resist hail and salt fog. The junction box carries built-in bypass diodes and MC4 leads. The same GB200W code is also used on an AeternaSol listing with the same 52.8 x 26.4 frame, which suggests a shared factory. The listing gives no Voc, Isc, cable length or bracket kit.
Putting two 200W panels to work
For a 12V bank, wire the pair in parallel into a PWM or MPPT controller; for 24V, wire them in series into an MPPT controller rated for the combined voltage. More panels can be added later in series or parallel for 24V or 48V systems. Once mounted, rinse dust and bird droppings off the glass now and then, and check the bolts after the first few weeks on a moving RV. EtnalSolar also says the panels work with portable power stations; check the station's input voltage before connecting a series pair.
EtnalSolar 2-pack checklist
Size, wiring and paperwork are the points to settle.
Check before you buy
- Your roof fits two 52.8 x 26.4 in EtnalSolar panels
- Your controller suits the EtnalSolar pair in series or parallel
- EtnalSolar can send the GB200W-B02 Voc and Isc
- You will buy brackets and cable for the EtnalSolar panels
- The EtnalSolar 10-year warranty terms suit you
The product at a glance
EtnalSolar 400W N-Type Solar Panel
Best for: Fixed RV and cabin arrays
- Rated Power
- 400W
- Conversion Efficiency
- 25.6%
- Cell Type
- N-Type Monocrystalline
- System Voltage
- 12V/24V
- Busbar Count
- 18BB
- IP Rating
- IP68
View on Amazon: EtnalSolar 400W N-Type Solar Panel Affiliate link
Two 200W 18BB N-type rigid panels (up to 25.6%) with 3.2mm low-iron glass, anodized frames, corner guards, bypass diodes and IP68. Each 52.8 x 26.4 x 1.18 in and 19.6 lb; rated -45°C to 85°C. 10-year warranty and 87.4% output at 30 years. No Voc or current listed.
Pros
- Long warranty and output guarantee
- N-type 18BB cells
- IP68 glass build
- Bypass diodes for shade
Cons
- No Voc, Vmp or Isc
- No brackets or cables listed
- Large 52.8-inch frames
Good fit if
- You are building a fixed 400W 12V or 24V array with EtnalSolar panels
- A long written warranty matters to you
Skip if
- You want a folding panel rather than EtnalSolar rigid frames
- Your roof is shorter than the EtnalSolar 52.8 inches
Verdict: Solid rigid pair with standout guarantee terms.
Specifications side by side
| Spec | EtnalSolar 400W N-Type Solar Panel |
|---|---|
| Rated Power | 400W |
| Conversion Efficiency | 25.6% |
| Cell Type | N-Type Monocrystalline |
| System Voltage | 12V/24V |
| Busbar Count | 18BB |
| IP Rating | IP68 |
| Weight | 19.6 pounds |
| Wattage | 200W |
| Application | Home, RV, Off-Grid, Marine |
| Features | Solar Charging |
| Voltage | 12V, 24V |
| Dimensions | 26.4 × 1.18 × 52.8 inches |
| Color | Black |
| Model | GB200W-B02 |
Frequently asked questions
Is 19.6 lb the weight of one EtnalSolar panel or both?
One; the same figure appears on EtnalSolar's single GB200W-B02 listing.
What output does EtnalSolar promise after 30 years?
87.4% of rated power, after no more than 1.0% loss in year one and 0.4% a year after.
Can the EtnalSolar 2x200W pair run a 24V system?
Yes, wired in series with a suitable MPPT controller; EtnalSolar also mentions 48V with more panels.
Do the EtnalSolar panels handle shade?
They have built-in bypass diodes, which reduce the loss from partial shading.
What warranty comes with the EtnalSolar GB200W-B02?
10 years on materials and workmanship plus the 30-year output guarantee.
Featured in
See also
- anker a1383 20000mah 87w power bank built in cable review
- lusperi 20ft 14awg 8mm dc7909 extension cable review
- grecell eb1000 999wh portable power station olive review
- etnalsolar 100w bifacial solar panel 2 pack review
- etnalsolar 200w n type solar panel review
- etnalsolar 400w n type solar panel review
- arctwonder solar panel rooftop tent review
